2.2 N-m (1.7 ft-lb) torque at 150 RPM. 4 M4 threaded holes located at front for face mounting.Motor length is 6.5 inch (165mm) long and its controller. Is integrated as part of the motor.
Shaft is 8mm in diameter with a flat and is 1 inch (25.4mm) long. Which contains speed adjustment (with a pot soldered already), reversing signal wire, on/off signal wire, and signal. Ground wire, is 20 inch (508mm) long. Connector line that is to connect to the power adapter is 20 inch (508mm). Motor control is very simple.To turn the motor OFF, simply connect the on/off (blue) wire to signal ground. A typical practice is to introduce a switch between the on/off wire and the ground wire, but one may. Decide to leave the on/off (blue) wire alone if on/off feature is not necessary. To reverse the rotation of the motor. Simply connect the reverse (white) wire to the same ground wire and the motor will reverse its rotation.
SURE THAT THE MOTOR IS AT FULL STOP BEFORE REVERSING. To vary the speed, simply turn the potentiometer. Power Adapter: The power cord is 5 ft(152 cm) long and has a standard plug ready to plug into a standard appliance.The adapter is able to universally accept 115v ac or 230v ac. Connector line that is to connect to the motor is. 3 ft (91 cm) long. Adapter's dimensions are 2.5 in(64mm) width by 4.75in(121mm) length by 1.75in(44mm) depth.
The item "110v 220v ac 150RPM Makermotor Gearmotor Variable Speed Brushless ECM Gear Motor" is in sale since Friday, July 29, 2016. This item is in the category "Business & Industrial\Automation, Motors & Drives\Electric Motors\Gearmotors". The seller is "blmotorking" and is located in Corona, California. This item can be shipped worldwide.