Continues back and forth until powered down. These are designed and hand engineered in our local workshop. These sliders are custom made which allows for a certain amount of customisation, but in its basic configuration it is built with a high quality'low noise' geared DC motor with a gearing ratio of 148:1 (approx 60 rpm), which when combined with the variable speed voltage regulator gives a travel time, over a 1m length of between 6 and 55 seconds.
It can be powered with either a 12v AC/DC mains adaptor or a battery system of between 6 - 15 volts, (12v li-ion system is recommended and can be supplied at additional cost). It is supplied with a 9v PP3 battery holder with a standard 2.1mm barrel connector which connects to the slider's DC input. It comes complete with a high quality camera carriage plate with a 3/8 captive bolt. The carriage itself is fitted with 4x delrin V slot wheels each with 2 bearings.
The wheels on one side have'eccentric' spacers which can be adjusted to vary the amount of drag on the carriage, particularly useful when used in manual mode. There are 2x tripod plates fitted to the underside both drilled and threaded for both 1/4-20 and 3/8-16 tripod plates. These are secured with T nuts which allow the plates to be placed and fixed at any point along its length. The slider can be supplied in both anodised matt silver or anodised matt black (as featured). Standard length is a total of 1.2m although any length below that can be supplied at no extra charge. For more product photos see. The item "Camera slider dual track motorised, variable speed with remote NEW PRICE" is in sale since Sunday, October 7, 2018. This item is in the category "Cameras & Photography\Tripods & Supports\Other Tripods & Supports". The seller is "klaatudude" and is located in Blackpool.This item can be shipped worldwide.