Speed ratio ingle-phase 110V/220V, the gearbox without gearbox is 1250 rpm, the need for different reduction ratio of customers please note and message. The load is relatively small and the motor does not work continuously for a long time, the governor shall not be less than 50% of the full speed. The load is relatively large and the motor works continuously for a long time, the governor shall not be less than 70% of the full speed. 1, Gear detector (all-round inspection of gears) 2, Vickers hardness tester, Rockwell hardness tester (test hardness again to ensure wear resistance) 3, Radial runout detection (detecting motor running-in, balance to reduce motor wear, no noise when running at high speed) 4, Withstand voltage tester (to detect leakage, higher than normal voltage, no leakage) 5, inter-turn tester, surge test motor stator winding insulation between turns, thick coil, same power torque output, larger torque 6, Stator comprehensive tester: Check for defects after the motor stator is embedded, and investigate and deal with unqualified defective producs (stator: the part of the motor that is fixed on the casing corresponding to the rotating part) 7, Motor comprehensive tester: test the data of the motor to meet the standard 8, Dynamometer: Welding, insulation, power frequency withstand voltage, turn-to-turn withstand voltage against any chip, any impact method and repeated impact times. This item is in the category "Business, Office & Industrial\Industrial Automation & Motion Controls\Electric Motors\Gearmotors".
The seller is "cardiffee" and is located in this country: CN. This item can be shipped worldwide.