At last I have some more stock. My apologies to waiting customers.
SPEED CONTROLLER / CONVERTER AC-DC. Replacement/Spare DC 500W Motor which can be used for vibration plate, exercise equipment, DIY project for lathe or other DIY use. Attaches via a metal plate with four large pre-drilled holes, this can be seen under motor on main photo.
Pulley accepts standard 10mm V-grooved belts. Search poly-V belt J section 4 rib. 15mm output shaft, grooved pulley held on with either an allen grub screw or compression fit (heat expands and removes easily).
Socket shown but most have just the wires to which connectors need attaching, these could easily be changed or adapted. Motor likely to have other uses as well. This kit has the speed controller and lead only, the controller converts AC to DC and the knob is initially an on/off switch then as you turn it a potentiometer is turned until max revs reached from zero start. Always turn off with the knob not just at power source. The speed controller is rated at 10 amp continuous and 20 amp peak so in theory will run up to 2000w.
The voltage range is 10 - 210 volts. It also runs my 200w motors available in separate listing. Some of these motors say 2000W on the body and this is a Chinese factory exaggeration, they are 500W!SEE OTHER LISTINGS FOR MOTOR ONLY AND THE FULL REMOTE/LCD KIT AND THE 200W KIT. The item "500W 220V DC Treadmill Motor DIY Project Electric Variable speed" is in sale since Thursday, November 15, 2018. This item is in the category "Business, Office & Industrial\Automation, Motors & Drives\Electric Motors\General Purpose Motors". The seller is "hebdenmotorbits" and is located in Hebden Bridge. This item can be shipped to United Kingdom.